All of the puck lights we have that may work with your 2015 Newmar Mountain Aire have plastic covers as opposed to glass, but they still mimic the glass look, weigh less, and are less prone to shattering so they still might work out for you.
According to my research your motorhome has "warm white" interior lighting so the 3-5/8" Diameter # 277-000488 or 4-3/8" Diameter # 277-000489 LED light from Gustafson looks to be the best replacement if the diameter matches.
I'm also attaching a... view full answer...
I have seen both the Steel # 9106 and Aluminum # RV-626-062 Pop-Up Vents used in a open position to allow the air to blow into the trailer while driving. While I do not see the manufacturer having any kind of speed rating on these I would be hesitant to the speed or having them opening forward depending on the material you are mounting it to. Since some trailers only use fiberglass shells I would not find that material secure enough to hold the vent open while driving. But if you have a... view full answer...
Yes, you can use the # TLL160RK on your 2019 Palomino Solaire 268BHSK without having to modify the rear of the trailer. These are surface mount lights so they can sit where the old lights were located. If you want an exact replacement it looks like it originally came with the # RVSTLB61 and # RVSTLB60. view full answer...
You would simply use the 7-Way Round RV Style Trailer Connector # A7WCB to change your boat trailer from the 4-Way Flat # 18172. The 7-Way Molded Trailer Wire Connector # H20043 you found would also work but it contains wires you do not need as you will still only connect your 7 wires to the 4 pins for the ground, running lights, and left/right turn signals/brake lights. view full answer...
Hi Brian,
The Furrion Chill HE Replacement RV Air Conditioner for Coleman Setup # FR82PV is plugging into your Coleman controller so you'd need to replace it with the same model Coleman controller in order for the rest of the system to properly function. We unfortunately don't carry the Coleman brand so you'd have to go to them directly in order to get a replacement. There's typically a freeze sensor that needs to connect to the coils, typically around the middle. If you have this in... view full answer...
If it works with the monitor but not when it's plugged in then it definitely sounds like there is a power issue at your plug. I'd recommend taking a volt meter # PT89ZR to your plug and make sure that the 12V pin has a full 12V going to it.
It also wouldn't hurt either to go through your wiring and make sure that there aren't any broken or damaged, and if they are replace the wire as needed and check again.
There is also a possibility that whatever adapter came with the camera that... view full answer...
Go To Results